Milling in acrylic glass, polycarbonate or makrolon
Engrave and/or mill in plexiglass, polycarbonate or Makrolon
Engraves are surly possible in diverse plastics like PVC, acrylic glass etc. Because of the low melting point of acrylic glass of approx. 80°C it is necessary to use a suction device in order to enable a permanent air cooling. Better results would be achieved by usage of spray cooling.
For clearer presentation we completely abstained from cooling.
Our production is currently unrestricted and technical support is also assured in the current tense situation. But we will keep you informed about changes here and contact you personally in case of possible date changes or similar.
All our end customers* receive a 10% discount** on our entire product range from order date 25.03.2020.
(*except end customers with resellers in their own country), (**not combinable with other discounts; 10% discount on the total invoice amount; probably valid until the WHO lifts the pandemic state, but we reserve the right to make changes)